Updating Your Multipliers

Your default multiplier is the starting rate for new calculations.

To update it, go to Settings. Set a new default for square inch and linear inch. From that point forward, new calculations open with that rate pre-filled.

Changing your default does not update any saved calculations. It only affects what you start with on a new run.

You can also adjust the multiplier per-calculation using the slider in the calculator. That changes the current calculation without touching your default... useful for testing different rate levels without committing to them.

When you are ready to raise your rate permanently, update the default in Settings. See How to Set Your Multiplier for when and how to make that call.